Recent content by Cazman

No one has any ideas how to make it stronger?

http://www.pitstopusa.com/detail.aspx?ID=55545

Thats what i was thinking and fearing. Any ideas? I can get some shanks turned up and threaded, and probly in decent steel too. I don't know what grade would be decent though The ones you can buy off the shelf look like this, but they all seem to have the wrong size taper and length for me...

I could use a large bolt, but it would mean drilling out the cast hub itself, not a difficult task, but when it comes to selling these parts as a "bolt on" item, its not something people will want to do. The load the bolt would see is impossible for myself to measure. It is a rear toe arm on a...

No there are spacers in there, click on the pic to see them. The factory joint was an m12 thread but had a large formed taper on it, what I want to know is, is a 12mm bolt through the middle going to be strong enough? The hubs have a taper in them that i can't avoid, 12mm is the biggest bolt I...

I have a suspension arm that I am rebuilding, the main reason is to make it adjustable in length, and the other is to replace the ball joint. The original equipment is a standard automotive ball joint, greased and the shaft is 1 piece with the ball. The new setup would use a 5/8 spherical...