I am working on a problem involving spray dryers. The material to be dryed would be injected through a centrifugal disk with spherical multiple openings of about 0.5 mm in diameter. Hot air would be blown from the dryer's bottom part. I was wondering how can I approach the problem to find out...
This is a spray dry atomizer problem. I have a shaft that rotates at 6000 ropm. On top of the shaft sits a bowl with two arms that are 180 degrees apart. At the end of each arm is a spray nozzle with a 5/32 inch hole. The length of each arm with the nozzle attached is 12 inches from the...
I was told that when you release spray from an aerosol can, the can cools down. Is this true, and if so, why?
Does the gas in the can require outside energy to expand and escape the can?
Thanks,
Alex