Co-Simulation of PMSM using ANSYS MAXWELL and Simplorer

[Omokhafe]

Hello everyone.
Am working three-phase PMSM using Ansys Maxwell and Simplorer. I created the design iin2D Maxwell and trying to co-simulate with Simplorer. Simulation completed with execution error. I would be very grateful if anybody can kindly let me know to resolve this issue.

 

[Aaron Barnard]

There are several possible causes for an execution error in a co-simulation setup between Ansys Maxwell and Simplorer. To troubleshoot the issue, we recommend that you check the following:

1. Make sure the version of Ansys Maxwell and Simplorer you are using are compatible.
2. Check that the model parameters, such as flux linkage, are correctly set in the Ansys Maxwell simulation.
3. Ensure the electrical and mechanical ports are properly connected between the tools.
4. Make sure the control signals from Simplorer are properly connected to the Ansys Maxwell model.
5. Check the scaling and range of the signals to make sure they are within the expected range.
6. Verify that the time step setting is appropriate for the simulation.
7. Make sure the electrical and mechanical parameters are consistent between the two tools.
8. Ensure the PMSM model parameters are correct.
9. Check the accuracy of the switching and timing of the control signals.

If you are still unable to resolve the issue, you may need to contact Ansys or Simplorer technical support for further assistance.