Does Wood on Wood Increase Frictional Force Compared to Other Surfaces?

  • Thread starter Thread starter oliviecheng
  • Start date Start date
AI Thread Summary
The discussion centers on the frictional force experienced by wood on wood compared to other surfaces like plastic and glass. An experiment indicated that a wooden block moves with less friction on plastic or glass than on wood. The presence of crests on wood raises questions about whether wood on wood would increase friction due to these interlocking features. Concerns were raised about trusting experimental results versus theoretical expectations. A homework question regarding the coefficient of kinetic friction for a wooden crate sliding across a floor was also presented, highlighting the urgency for assistance.
oliviecheng
2
0
i have done an experiment to find the force of friction on several surfaces.but i found that the wooden block used can move in a smaller frictional force than on plastic or glass
Will the frictional force be smaller when the same material is used(wood on wood)?but there are many crests on wood, when the wooden block moves, crests will hit crests and make the block more difficult to move.
i suppose the frictiional force(wood on glass or plastic)is smaller then that of wood on wood
 
Physics news on Phys.org
It is not clear to me, what your question is.
 
Your only "problem" seems to be whether to trust your results. I would consider it very bad science to refuse to accept the results of an experiment because of some notion of what "should" happen.
 
need help with homework pleasez help

al right the problem is (If u use a horizontalforce of 30.0N to slide a 12.0-kg wooden crate across a flor at a constant velocity, what is the coefficient of kinetic friction between the crate and the floor?) PLz help answr fast its due tmrw ahhhhh!
 
Thread 'Minimum mass of a block'
Here we know that if block B is going to move up or just be at the verge of moving up will act downwards and maximum static friction will act downwards Now what im confused by is how will we know " how quickly" block B reaches its maximum static friction value without any numbers, the suggested solution says that when block A is at its maximum extension, then block B will start to move up but with a certain set of values couldn't block A reach...
TL;DR Summary: Find Electric field due to charges between 2 parallel infinite planes using Gauss law at any point Here's the diagram. We have a uniform p (rho) density of charges between 2 infinite planes in the cartesian coordinates system. I used a cube of thickness a that spans from z=-a/2 to z=a/2 as a Gaussian surface, each side of the cube has area A. I know that the field depends only on z since there is translational invariance in x and y directions because the planes are...
Thread 'Calculation of Tensile Forces in Piston-Type Water-Lifting Devices at Elevated Locations'
Figure 1 Overall Structure Diagram Figure 2: Top view of the piston when it is cylindrical A circular opening is created at a height of 5 meters above the water surface. Inside this opening is a sleeve-type piston with a cross-sectional area of 1 square meter. The piston is pulled to the right at a constant speed. The pulling force is(Figure 2): F = ρshg = 1000 × 1 × 5 × 10 = 50,000 N. Figure 3: Modifying the structure to incorporate a fixed internal piston When I modify the piston...
Back
Top