- #1
NeutronStar
- 419
- 1
I have both the TI-89 and the TI-92 graphing calculators. I like them just fine but I can't figure out how to abort a plot. There doesn't seem to be any mention of how to do this in the manual.
Once a plot is started there doesn't seem to be any way to stop a plot until it has been completed. This can be really frustrating if a very small step size was used, or if there was an error in an equation assignment. You have to wait for the entire plot to finish before you can correct the mistake. This can sometimes take quite a while.
Does anyone know how to abort a plot on these calculators?
I've tried using Esc, and 2nd Quit. I've even tried shutting the whole calculator off, but it won't even turn off when plotting! I've discovered that a plot can be paused by pressing the Enter key. But even then the calculator still won't respond to other commands until the plot has been restarted and completed.
Does anyone know how to abort a plot on these calculators?
Thank you
Once a plot is started there doesn't seem to be any way to stop a plot until it has been completed. This can be really frustrating if a very small step size was used, or if there was an error in an equation assignment. You have to wait for the entire plot to finish before you can correct the mistake. This can sometimes take quite a while.
Does anyone know how to abort a plot on these calculators?
I've tried using Esc, and 2nd Quit. I've even tried shutting the whole calculator off, but it won't even turn off when plotting! I've discovered that a plot can be paused by pressing the Enter key. But even then the calculator still won't respond to other commands until the plot has been restarted and completed.
Does anyone know how to abort a plot on these calculators?
Thank you