- #1
ineedmunchies
- 45
- 0
Ok, so I have an assignment I need help with. Hopefully some of you here will be able to help me with it.
The Question is shown in the attatched files question2a + question2a2.
I think what I need to do first is represent the system in a block diagram. I have included a rough one of what I think it will be. Where it says Ki0i it should infact say [tex]K_{1}[/tex][tex]\theta_{o}[/tex]. I couldn't figure out how to do subscript in paint.
I don't know whether I should then try and simplify this as much as possible, or whether I should try and split it into sections.
One section to represent the second order terms, one section to represent the first order terms and one section to represent the output angle.
Any help or discussion about this would be greatly appreciated. Thank you.
The Question is shown in the attatched files question2a + question2a2.
I think what I need to do first is represent the system in a block diagram. I have included a rough one of what I think it will be. Where it says Ki0i it should infact say [tex]K_{1}[/tex][tex]\theta_{o}[/tex]. I couldn't figure out how to do subscript in paint.
I don't know whether I should then try and simplify this as much as possible, or whether I should try and split it into sections.
One section to represent the second order terms, one section to represent the first order terms and one section to represent the output angle.
Any help or discussion about this would be greatly appreciated. Thank you.