- #1
sunovya
- 2
- 0
Sir,
I stuck with a project. It is a bearing supported 5 Meter long cylinder with 1.5 meter diameter and weighs approximately 8 tons. At first stage I need to rotate this cylinder from 0-200 RPM within 1 minute and keep that RPM for 10 minutes and again from 200-1200 within 1 minute and keep this RPM for 30-45 Minutes, then bring down to 0 RPM, using a speed controlled(ATB) A/c Motor with suitable reduction gear system.
Kindly advice how to calculate the Initial torque to find out the correct capacity motor for this project
Thanks
Sunovya
I stuck with a project. It is a bearing supported 5 Meter long cylinder with 1.5 meter diameter and weighs approximately 8 tons. At first stage I need to rotate this cylinder from 0-200 RPM within 1 minute and keep that RPM for 10 minutes and again from 200-1200 within 1 minute and keep this RPM for 30-45 Minutes, then bring down to 0 RPM, using a speed controlled(ATB) A/c Motor with suitable reduction gear system.
Kindly advice how to calculate the Initial torque to find out the correct capacity motor for this project
Thanks
Sunovya