Homework Statement
Homework Equations
Adding inductors in series and parallel (same as resistors)
The Attempt at a Solution
This is the first time I ran into a circuit like this with diagonal wiring and I am not sure how to treat it. Do I add the inductors in the triangle in series? So...
Homework Statement
Homework Equations
Series: 1/Ceq=1/C1+1/C2
Parallel: Ceq =C1+C2
The Attempt at a Solution
So to find the equivalent resistance do I short (put a wire through the open terminals) the circuit and start adding up the capacitors? Once I do that do I just create a new circuit...
Homework Statement
[/B]
I am studying a book related to digital integrated circuits and there is something I cannot understand.
The book starts by explaining two basic building blocks of digital integrated circuits: the inverter and the non-inverter. My question is about the inverter.
It...
Homework Statement
Find the Norton equivalent at the terminals.
Homework Equations
V=IR
The Attempt at a Solution
I did the thevenin equivalent, but I'm not sure where to go from there. How do I get the Norton equivalent out of this? [/B]
Homework Statement
Homework Equations
V=IR
The Attempt at a Solution
I am not sure if I did this problem correctly. To find the thevenin equivalent do you have to get the circuit into series first? I combined the resistors in parallel and found the Vth to be 6V and Rth to be 8ohms. Is...
Homework Statement
If k is a positive integer, then show that
##\lim_{x\to\infty} (1+\frac{k}{x})^x = \lim_{x\to 0} (1+kx)^\frac{1}{x}##
Homework Equations
L'Hopitals rule, Taylor's expansion
The Attempt at a Solution
How should I begin? Should I prove that both has the same limit, or is...
Homework Statement
I am having trouble simplifying a circuit of capacitors that I was given. I am asked to determine the equivalent capacitance of the combination below (attached photo).
Homework Equations
Capacitors in series: 1/Ceq = 1/C1+1/C2+...
Capacitors in parallel: Ceq = C1 + C2 +...
Simple as that, I've uploaded the image. I don't really care about the exact value, I would prefer just to know the method. So how would I find the equivalent resistance between A and B? Note the component in the middle is a constant current source.
Homework Statement
Find the equivalent resistance between AB.
Homework EquationsThe Attempt at a Solution
I could not find any Wheatstone bridge or series parallel combination. Should I use star delta transformation ? If yes, how exactly should I use it ?
I have created a circuit diagram for a single phase CSCR induction motor, but only for the purpose of calculating start-up current (i.e. motor speed is at, or very near, zero RPM). I have created this diagram because: 1) I do not have the tools & knowledge required to generate the Steinmetz...
Homework Statement
i am asked to find the equivalent resultant force for this question . for the distributed load , i divided into 4 parts , is my method correct?
Homework EquationsThe Attempt at a Solution
total force about y = 6sin30 + 3(3) + (5-3)(0.5)(3) + 5(4) + (7-5)(4)(0.5)
total...
Homework Statement
Hi everyone, I'm just having a little trouble with equivalent resistance in a bridge, in the image I attached. The textbook says that the way to solve this is to put R3 and ZL2 in series, that series is in parallel to the short circuit in diagonal, and then at the end we...
Hello,
I am searching for some kind of transform if it is possible, similar to a Fourier transform, but for an arbitrary function.
Sort of an inverse convolution but with a kernel that varies in each point.
Or, like I say in the title of this topic a sort of continuous equivalent of fitting a...
Homework Statement
https://z-1-scontent-sin1-1.xx.fbcdn.net/hphotos-xtf1/v/t34.0-12/12435980_942112312550457_1708451532_n.jpg?oh=b29a5e9b2ff96bbf0e11932d081eb25e&oe=568A9B79 [/B]
We need to find the equivalent resistance along A to B ie AB
Homework Equations
R=(1/R1 + 1/R2+...+1/Rn)^-1 ...
Homework Statement
R = 10 Ohms
Homework Equations
Req = (1/R1 + 1/R2 + ... )(-1)
Req = R1 + R2 + ...
The Attempt at a Solution
I honestly don't even know where to start...
The obvious thing to do is
4R + 2R = 6R
That's pretty much all I can come up with that makes sense... Any help?
Homework Statement
Homework Equations
-We can re-arrange circuit components into simpler orientations as long as the components' connections to previous nodes are maintained.
The Attempt at a Solution
-I attempted to re-arrange the loop of three resistors at the upper left region to no...
Hey! :o
Suppose we have the system $$\exists y (G(y)=f \land G_1(y)\neq g_1 \land G_2(y)\neq g_2).$$
Is this equivalent to $$\not\exists y \ \left (G(y)=f \land G_1(y)= g_1 \land G_2(y)= g_2) \ \land \ \exists \ x(G(x)=f\right )$$ ?
Or to $$\not\exists y_1, \not\exists y_2 \ \left...
I found this question here
but i do not understand the answer. One equation is from classical physics and the other from quantum physics. Is there another way to go from classical to quantics than the analytical extension?
Homework Statement
http://puu.sh/lQPvh/d0efa216ff.png
Homework EquationsThe Attempt at a Solution
http://puu.sh/lQPAR/2456db4783.jpg
http://puu.sh/lQPCJ/f142c25f63.jpg
http://puu.sh/lQPER/5eb4af107e.jpg
Is this correct? I used principle of superposition to calculate the Thevenin...
Homework Statement
If 100 volts of potential difference is applied between a and b in the circuit .Find the potential difference between c and d.
2. Homework Equations
For Equivalent Capacitance in series
##\frac{1}{C}##=##\frac{1}{C_1}##+##\frac{1}{C_2}##For Equivalent Capacitance in...
Homework Statement
Find the equivalent capacitance of the combination between A and B in the figure.
Homework Equations
For Equivalent Capacitance in series
##\frac{1}{C}##=##\frac{1}{C_1}##+##\frac{1}{C_2}##For Equivalent Capacitance in parallel
##C##=##C_1##+##C_2##...
The Attempt at a...
Homework Statement
Five capacitors ,each of capacitance value C are connected as shown in the figure.The ratio of capacitance between P and R,and the capacitance between P and Q is
Homework Equations
For Equivalent Capacitance in series
##\frac{1}{C}##=##\frac{1}{C_1}##+##\frac{1}{C_2}##...
Mentor's note: Post moved to new thread since it's a new problem.
One more problem
Homework Statement
Find the equivalent capacitance between A and B.
Homework Equations
The Attempt at a Solution
I think all the Capacitors are in series but according to my book only three capacitors are in...
Homework Statement
I need to find equivalent capacitance between A and B.
Homework Equations
##C##=##C_1##+##C_2##...
It was for parallel connection.
##\frac{1}{C}##=##\frac{1}{C_1}##+##\frac{1}{C_2}##...
It was for series connection.
The Attempt at a Solution
I tried to solve the problem...
Ok, so I know the point of the Thevenin is to make a simpler circuit so that that it results in the same current being sent to the other connected circuit. But why do we go through all the hassle of computing the Thevenin Voltage when we could choose any arbitary Voltage and a Resistor that...
Homework Statement
Find the Thevenin equivalent circuit for the circuit shown. You will need to find VOC and then use the test source method to find the Thevenin resistance. Using the Thevenin equivalent circuit,determine the load resistor that results in maximum power transferred to that load...
well in midfrequency the transistor has a simplified equivalent system . our professor told us that even though pnp and npn transistors have different current directions they both have the same circuit, and that the direction of the currents in the equivalent circuit doesn t change whether it s...
Homework Statement
[/B]Homework Equations
[/B]
Node-voltage method
mesh current methodThe Attempt at a Solution
[/B]
My problem is with the short-circuit current.
There are three meshes when you join the nodes a and b.
Let i1 be the cw current for the bottom right mesh, i2 be the ccw...
Homework Statement Homework EquationsThe Attempt at a Solution
So far I've found Vout, but I'm a little confused about finding ISC. The solution to my homework says that in Figure 2 the 10 ohm resistor gets by passed due to the short across the open voltage. Why does this happen? Thanks!
Given an electric circuit, with resistors R1 and R2, find the equivalent resistance R.
Data: R1 = √2.R2
Points M and N have the same electric potential so they can be connected with a conductor and this way we get the second circuit.
I am currently learning about Thevenin equivalent circuits and was posed with the question attached to this post. I was wondering why I3 is equivalent to the current formed by a short circuit between nodes a and b. Shouldn't the current between a and b be I1 + I2 + I3 since in a short circuit...
Homework Statement
Two thin lenses have focal lengths of -5cm and +20cm. Determine their equivalent focal lengths when (a) cemented together and (b) separated by 10cm.
Homework Equations
##\frac{1}{f_{eq}}=\sum_{n=1}^k \frac{1}{f_n}##
The Attempt at a Solution
So the first part was easy since...
Homework Statement
Find the open circuit voltage V0, short circuit current ISC, and RTH,
Homework EquationsThe Attempt at a Solution
I found the equivalent resistance to be 20 ohms(just by combining resistors in parallel and series) and V0 to be 30V, which I think might be wrong.
I did a...
Hello,
I am trying to calculate the equivalent amount of weight that a submarine would be under at 1000m below the sea. Apologies if this isn't that well explained!
At 1000m - 101 atmospheres - which is 14.5 psi per atmosphere - so at 1000m it would be 1464.5 psi.
Do I then multiple 1464.5 by...
Homework Statement
Homework EquationsThe Attempt at a Solution
(a)I think there are two pairs of resistances are in parallel,one pair is the 40ohm and 50ohm resistances,and the other pair is the 30ohm and 60ohm resistances.But I'm not to sure:oldfrown:
So the Req I've calculate is 152.2ohm...
Hi all :)
I'm trying to figure out the Thevenin equivalent of this circuit:
I start by switching off every source and calculating the equivalent resistance:
RTh = RN = (6 + 14) || 5 = 4 Ω
Then I proceed with finding the voltage at 2.
I note that the nodes between 1 and 2 form a...
Homework Statement
I came across a problem and I was unable to understand how the effective resisitance of this circuit is to be calculated.
(Please refer to image uploaded)
Homework EquationsThe Attempt at a Solution
Well I assumed that current tends to flow through wires without resistances...
I heard that, emf cannot be parallely connected provided that the value of the emf are not same.
Is this correct? Like, what would happen when batteries with 3V, 4V, 5V are parallely connected? And the equivalent emf?
Hello Everyone,
Can someone pleas help me to find out the equivalent material for the EN39B steel in Chinese (GB) standard.
I found other equivalents
AS X9315 / EN39B
Germany DIN: 15NiCrMo16-5
Great Britain 835M15 or 835H15
Japan SNCM 815, JIS G 4103
USA EN: 39B
but its little bit difficult to...
Homework Statement
Find the equivalent resistance between A and B. All resistances shown are in ohm.
Homework Equations
The formulas for parallel and series connections.
The Attempt at a Solution
I have attempted to redraw the circuit and my redrawn diagram looks like this.
I don't think...
I have just posted on the Linear and Abstract Algebra forum ... and the post needs a "not equivalent" symbol as shown in Rotman's Proposition 1.58 part (ii) see below ...
Can someone please help with the latex code for this symbol?
PeterProposition 1,58 in Rotman's Abstract Algebra reads as...
Question: A 1-microF capacitor and a 1-kOhm resistor are connected in parallel, and this parallel combination is connected in series with a 200-mH inductor. Find the equivalent impedance of the connection at w=1 krad/s.
Relevant Equations: Z=R for a resistor, Z=jwl for an inductor, and...
Hello, I need to figure out the max water depth a motor will operate without water ingress. The plan is to use a vacuum pump to create differential pressure and correlate that to water depth. My issue is the correlation between the vacuum and pressure. Can someone please provide a formula for...
One has to calculate the equivalent DC-current in order to provide the same power on a load like a sine, triangular and square wave current do in average.
I know the general formula for the average power of an AC-current is:
p_{average} = \frac{R}{T} \int_0^T i(t)^2 \, dx
For the sine...
I've seen various different matrices used to represent beam splitters, and am wondering which is the "right" one. Alternatively, are there various kinds of beam splitters but everyone just ambiguously calls them the same thing?
The matrices I've seen are the...
Homework Statement : [/B]Given the circuit diagram, find the equivalent resistance between points P and Q. Homework Equations : [/B]ΔVloop = 0, ΔIjunction = 0 and V = IRThe Attempt at a Solution : [/B]Eliminating the wires with no resistors and solving for resistance gives me the answer as...
Homework Statement
Hello, I am going to ask a rather simple question yet I wasn't able to solve. I have a circuit which I wanted to find out about the equivalent resistance and inductance. I know how to find the equivalent resistance of two resistors in parallel as well as two inductors in...
Hello! (Wave)
A physical system is described by a law of the form $f(E,P,A)=0$ where $E,P,A$ represent, respectively, enery, pressure and area of surface. Find an equivalent law that relates suitable dimensionless quantities.
I have tried the following:
The fundamental units are:
Mass: $M$...