Answer Check for kinematic in 2-d

  • Thread starter Thread starter Filenes
  • Start date Start date
  • Tags Tags
    Kinematic
AI Thread Summary
The discussion revolves around a physics problem involving the motion of a beer mug sliding off a counter. The correct initial velocity of the mug as it leaves the counter is determined to be 2.68 m/s. For the direction of the mug's velocity just before impact, the initial calculations were incorrect, leading to confusion about the angle. The x-component of the velocity remains constant at 2.68 m/s, while the y-component is recalculated to be 4.01 m/s, affecting the impact angle. The participants emphasize the importance of correctly applying kinematic equations to resolve the discrepancies in the y-velocity.
Filenes
Messages
4
Reaction score
0

Homework Statement



In a local bar, a customer slides an empty beer mug down the counter for a refill. The bartender is momentarily distracted and does not see the mug, which slides off the counter and strikes the floor 1.10 m from the base of the counter. The height of the counter is 0.820 m.
(a) With what velocity did the mug leave the counter?
correct check mark m/s
(b) What was the direction of the mug's velocity just before it hit the floor?
wrong check mark
Your answer differs from the correct answer by 10% to 100%.° (below the horizontal)

Homework Equations


I found (a) which is 2.68 m/s


The Attempt at a Solution



For b) i used sqrt(2.68^2+2.68^) = 3.79 and did,
theta = cos^-1(2.68/3.79) which is 45 degrees, which is wrong but since it say below the horizontal axis, will it be -315 degree?
 
Physics news on Phys.org
Filenes said:

Homework Statement



In a local bar, a customer slides an empty beer mug down the counter for a refill. The bartender is momentarily distracted and does not see the mug, which slides off the counter and strikes the floor 1.10 m from the base of the counter. The height of the counter is 0.820 m.
(a) With what velocity did the mug leave the counter?
correct check mark m/s
(b) What was the direction of the mug's velocity just before it hit the floor?
wrong check mark
Your answer differs from the correct answer by 10% to 100%.° (below the horizontal)

Homework Equations


I found (a) which is 2.68 m/s


The Attempt at a Solution



For b) i used sqrt(2.68^2+2.68^) = 3.79 and did,
theta = cos^-1(2.68/3.79) which is 45 degrees, which is wrong but since it say below the horizontal axis, will it be -315 degree?

I got the same for part a but I got something different for the impact angle.

the impact creates a triangle with x velocity and y velocity at impact. x velocity is constant at 2.68 m/s and I get 4.01 m/s for y velocity. Just finish it and you should get the right answer.
 
thanks alot.. now i got to figure out why is the y velocity different .. thanks!
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Correct statement about a reservoir with an outlet pipe'
The answer to this question is statements (ii) and (iv) are correct. (i) This is FALSE because the speed of water in the tap is greater than speed at the water surface (ii) I don't even understand this statement. What does the "seal" part have to do with water flowing out? Won't the water still flow out through the tap until the tank is empty whether the reservoir is sealed or not? (iii) In my opinion, this statement would be correct. Increasing the gravitational potential energy of the...

Similar threads

Replies
4
Views
2K
Replies
4
Views
4K
Replies
12
Views
8K
Replies
3
Views
2K
Replies
7
Views
9K
Back
Top