Calculating Electric Flux Through a Rectangle with Given Electric Field

AI Thread Summary
To calculate the electric flux through a rectangle in the xy-plane with an electric field E=(80.0i + 50k) N/C, first convert the rectangle's dimensions from centimeters to meters, resulting in an area of 0.00162 m². The electric field's magnitude is approximately 94.34 N/C, but the correct approach requires using vector multiplication rather than just magnitudes. The cosine of the angle between the electric field vector and the normal to the surface must be considered for accurate flux calculation. The initial attempt at calculating the electric flux was incorrect due to this oversight.
arileah
Messages
8
Reaction score
2

Homework Statement


Hello,

A 3.60cm x 4.50cm rectangle lies in the xy-plane. What is the electric flux through the rectangle if E=(80.0i + 50k) N/C ?

Homework Equations



Φ = E * A =EAcos(θ)

The Attempt at a Solution



My attempt:

First convert the rectangle units from cm to m.

4.50cm = 0.045m
3.60cm = 0.036m

Find the area of the rectangle.

A = 0.036m x 0.045m = 0.00162 m^2

Find the magnitude of the electric field.

E = sqrt (50^2 + 80^2) = 94.34 N?C (aprox.)

Multiply the two,

electric flux = E * A = 0.15283 Nm^2 / C (aprox.)

However, this answer is wrong. Could anyone point me in the right direction? I am not sure how to incorporate the cosine into this. Thank you.
 
Physics news on Phys.org
BvU said:
Your error is at the point where you multiply the two: that is a vector multiplication, not a magnitude multiplication.
 
Thanks!
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Correct statement about a reservoir with an outlet pipe'
The answer to this question is statements (ii) and (iv) are correct. (i) This is FALSE because the speed of water in the tap is greater than speed at the water surface (ii) I don't even understand this statement. What does the "seal" part have to do with water flowing out? Won't the water still flow out through the tap until the tank is empty whether the reservoir is sealed or not? (iii) In my opinion, this statement would be correct. Increasing the gravitational potential energy of the...
Back
Top