Calculating Kinetic Energy of Fridge Pushed 5m

AI Thread Summary
The discussion focuses on calculating the kinetic energy of a refrigerator pushed by a force of 180N against a frictional force of 35N. The net force on the fridge is determined to be 145N, leading to an acceleration of 2.57 m/s² for a mass of 70kg. After being pushed 5m, the final velocity is calculated to be 5.06 m/s. The kinetic energy of the fridge at that point is found to be 896.13J. The user expresses concern about potentially receiving low marks on an exam due to calculation errors and seeks urgent assistance.
AHUGEMUSHROOM
Messages
21
Reaction score
0
Q: A young Mr. Watford applies a force of 180N to a refrigerator on. kitchen floor.

Part (A):Find the net force on the refrigerator if the floor has a constant frictional force of 35N.

Ans:145N

Part (B): Calculate the acceleration of the refrigerator if it has a mass of 70kg.

Ans: 2.57 ms-2

Part (C) Calculate the kinetic energy of the fridge after it has been pushed 5.00m.

initial velocity = 0 ms-1
displacement = 5m
acceleration = 2.57 ms-2
mass = 70kg
time = ?s = ut + 1/2at^2
v = u + at
Ek=1/2 mv^2Substituting the given units into s = ut + 1/2at^2, I got time = 1.97s

Substituting the units into v = u + at, I got final velocity = 5.06 ms-1

And finally subbing the units into Ek= 1/2mv^2, I got Kinetic Energy = 896.13J.

I got one benefit of the doubt mark out of four possible marks, and if that was in an exam I would've got 0 marks as there are no benefit of the doubt marks.

Please reply asap I have an exam tomorrow.

Thanks

*ANSWERED*

E = W
W= Fs
=180 x 5 = 900J
 
Last edited:
Physics news on Phys.org
Give us the entire problem statement, and you might get some constructive suggestions.
 
SteamKing said:
Give us the entire problem statement, and you might get some constructive suggestions.

Fixed! :)
 
Rethink your calculation for the acceleration. The mass of the fridge will respond to the net force applied to it.
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Correct statement about a reservoir with an outlet pipe'
The answer to this question is statements (ii) and (iv) are correct. (i) This is FALSE because the speed of water in the tap is greater than speed at the water surface (ii) I don't even understand this statement. What does the "seal" part have to do with water flowing out? Won't the water still flow out through the tap until the tank is empty whether the reservoir is sealed or not? (iii) In my opinion, this statement would be correct. Increasing the gravitational potential energy of the...
Back
Top