Can a Red Plastic Cover Improve an IR Sensor Performance?

  • Thread starter Thread starter Firefox123
  • Start date Start date
  • Tags Tags
    Detector Ir
AI Thread Summary
Using a red plastic cover over an IR sensor may impact its performance, depending on the filter's transmission characteristics. If the cover allows high transmission at the laser wavelength (around 904 nanometers) while blocking other wavelengths, it can enhance the signal-to-noise ratio. However, if the sensor already has a narrow band filter, adding a red cover may yield minimal improvements. The effectiveness of the cover ultimately hinges on its specific optical properties. Overall, the potential benefits of a red plastic cover on IR sensor performance are contingent on existing filtering mechanisms.
Firefox123
Messages
183
Reaction score
1
IR Detector Question...

If someone take an IR sensor and puts a red covered piece of plastic over the sensor...is that really going to significantly affect the performance?

A friend of mine has a laser detector for road use and it appears to have a red plastic cover over the IR sensor...

Police operate at 904 nanometers...is a red plastic cover really going to improve the performance of the IR sensor by acting as a type of "filter"?

I'm having a hard time believing this...
 
Physics news on Phys.org
If the filter has high transmission at the laser wavelength and lower transmission at other wavelengths, then yes. The filter will increase the signal to noise ratio of the detected radiation. Unless, of course, if the laser detector already has a narrow band filter, then adding another one has marginal returns.
 
Consider an extremely long and perfectly calibrated scale. A car with a mass of 1000 kg is placed on it, and the scale registers this weight accurately. Now, suppose the car begins to move, reaching very high speeds. Neglecting air resistance and rolling friction, if the car attains, for example, a velocity of 500 km/h, will the scale still indicate a weight corresponding to 1000 kg, or will the measured value decrease as a result of the motion? In a second scenario, imagine a person with a...
Scalar and vector potentials in Coulomb gauge Assume Coulomb gauge so that $$\nabla \cdot \mathbf{A}=0.\tag{1}$$ The scalar potential ##\phi## is described by Poisson's equation $$\nabla^2 \phi = -\frac{\rho}{\varepsilon_0}\tag{2}$$ which has the instantaneous general solution given by $$\phi(\mathbf{r},t)=\frac{1}{4\pi\varepsilon_0}\int \frac{\rho(\mathbf{r}',t)}{|\mathbf{r}-\mathbf{r}'|}d^3r'.\tag{3}$$ In Coulomb gauge the vector potential ##\mathbf{A}## is given by...
Thread 'Does Poisson's equation hold due to vector potential cancellation?'
Imagine that two charged particles, with charge ##+q##, start at the origin and then move apart symmetrically on the ##+y## and ##-y## axes due to their electrostatic repulsion. The ##y##-component of the retarded Liénard-Wiechert vector potential at a point along the ##x##-axis due to the two charges is $$ \begin{eqnarray*} A_y&=&\frac{q\,[\dot{y}]_{\mathrm{ret}}}{4\pi\varepsilon_0 c^2[(x^2+y^2)^{1/2}+y\dot{y}/c]_{\mathrm{ret}}}\tag{1}\\...
Back
Top