Can Light Be Trapped Between Mirrors and Is There Energy Loss?

  • Thread starter Thread starter abc007
  • Start date Start date
  • Tags Tags
    Light
AI Thread Summary
Trapping light between mirrors is theoretically possible, but practical limitations exist due to imperfections in mirror surfaces that cause energy loss. Total internal reflection, as seen in optical fibers, demonstrates how light can be guided, but mirrors cannot achieve perfect reflection angles. When two mirrors are placed opposite each other, reflections diminish over time due to these imperfections. The discussion suggests that while current technology cannot create perfect mirrors for trapping light indefinitely, theoretical frameworks exist that could allow for such a phenomenon. Energy loss remains a significant factor in any practical attempt to trap light.
abc007
Messages
30
Reaction score
0
can we trap light?

hi every body
i read about Optical fiber and how light is reflecting inside wire by the principle of Total internal reflection and I wonder, is it possible to trap light between mirrors and if yes,then is it going to be an energy losses ??
:confused:
 
Science news on Phys.org


I don't think we can trap light because there can't be perfect angle so that light could come in and don't come out
 


Between normal mirrors that we can produce with todays technology, there will always be losses, you can see this when you hold two mirrors opposite each other, in theory the reflections should go on for ever, but in practice they curve away due to imperfections in the mirror.

However, I don't think that there is anything (theoretically) stopping someone from trapping light in that way.
 


Thank you for replying

but how the mirror will arrange to make it theoretically possible ?
 
Thread 'Simple math model for a Particle Image Velocimetry system'
Hello togehter, I am new to this forum and hope this post followed all the guidelines here (I tried to summarized my issue as clean as possible, two pictures are attached). I would appreciate every help: I am doing research on a Particle Image Velocimetry (PIV) system. For this I want to set a simple math model for the system. I hope you can help me out. Regarding this I have 2 main Questions. 1. I am trying to find a math model which is describing what is happening in a simple Particle...
Thread 'How to model converging illumination through object plane (in ZEMAX)'
Hello community, I'm designing a projection lens system for a 35mm film projector in Zemax OpticStudio and struggling with the correct sequential mode setup for the illumination geometry. The light source is a Xenon short-arc lamp reflected by an ellipsoid mirror, which creates a converging cone with a 40.6 degree full angle that passes through the film gate. The film gate is my object plane, but the light doesn't diverge from it like a typical Lambertian source. Instead, the converging...

Similar threads

Replies
22
Views
3K
Replies
2
Views
2K
Replies
22
Views
3K
Replies
10
Views
887
Replies
1
Views
1K
Replies
2
Views
6K
Replies
2
Views
1K
Replies
6
Views
3K
Back
Top