Conservation of energy and rotational energy -

AI Thread Summary
A solid, uniform spherical ball rolls up a hill and then falls off a cliff, prompting a discussion on how to calculate its landing distance and speed using conservation of energy and projectile motion. The initial velocity at the top of the hill is determined to be 25 m/s, with a height of 28 m. By applying conservation of energy, the final velocity before landing is calculated to be approximately 15.26 m/s. The time of flight is found to be about 2.39 seconds, leading to a horizontal distance from the cliff of approximately 36.47 meters. The final speed upon landing combines both vertical and horizontal components, resulting in a total speed of about 27.96 m/s.
lightonahill7
Messages
8
Reaction score
0

Homework Statement



A solid, uniform spherical ball rolls without slipping up a hill. At the top of the hill it is moving horizontally, and then it goes over a vertical cliff. How far from the foot of the cliff does the ball land, and how fast is it moving before it lands.

Use conservation of energy to find the velocity of the ball at the top of the cliff. Then use projectile motion to find how far it falls. Use table to find moment of inertia of the ball.


Homework Equations





The Attempt at a Solution

 

Attachments

  • 0009ra.jpg
    0009ra.jpg
    8.8 KB · Views: 1,887
Physics news on Phys.org
Welcome to PF lightonahill7!

What are your initial thoughts so far? We will guide you from where you are facing problem.

Delzac
 
Vo = 25 m/s
Please look over my solution to see if I am right.

h = 28 m
I = 2/5mr^2
w (omega) = v/r initital
wfinal = vfinal/r

Conservation of energy

1/2mvo^2 + 1/2Iw1^2 = mgh + 1/2mvfinal^2 + 1/2Iwfinal^2

This is equation one.

2 unknowns w (omega) and Vfinal

Rolling w/o slipping means that w= v/r

1/2Iw^2 = 1/2(2/5mr2)(v/r)2 = 1/5mv^2 - Equation 2

Substitue into equation 1 and solve for vfinal

1/2mvo^2 + 1/5mvo^2 = mgh + 1/2mv2^2 = 1/5mv2^2

7/10mv1^2 = mgh + 7/10mv2^2

v2^2 = (v1^2 - 10/7gh)^1/2

= [(25}^2 - 10/7(9.8)(28)]^1/2

= (233)^1/2

v2 = 15.26 m/s

Determine the time in the air?

y-component

Voy = 0

ay = 9.8 m/s^2

y-yo = 28 m/s

28 = voy + 1/2 ayt^2

t^2 = 28/4.9

t^2 = 5.71

t=2.39 s

x-component - distance from cliff

d = vfinal*t
= 15.26 m/s(2.39 s)
= 36.47 m

How fast is it moving before it lands?

vy = voy + ayt
= (9.8)(2.39)
= 23.42 m/s

vx = Vox = 15.3 s

v = [(23.4)^2 + (15.3)^2]
= (781.65)^1/2
= 27.96 m/s
 
hi lightonahill7!

(have an omega: ω and try using the X2 and X2 icons just above the Reply box :wink:)

yes that's all ok :smile:

(though you should probably have less sig figs in the answers :wink:)
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Correct statement about a reservoir with an outlet pipe'
The answer to this question is statements (ii) and (iv) are correct. (i) This is FALSE because the speed of water in the tap is greater than speed at the water surface (ii) I don't even understand this statement. What does the "seal" part have to do with water flowing out? Won't the water still flow out through the tap until the tank is empty whether the reservoir is sealed or not? (iii) In my opinion, this statement would be correct. Increasing the gravitational potential energy of the...
Back
Top