Converting Units: Solving a Simple Density Problem

  • Thread starter Thread starter Psip
  • Start date Start date
  • Tags Tags
    Unit conversion
AI Thread Summary
The discussion revolves around a density problem involving the conversion of units to determine the mass of a cube of water with a side length of 10 cm. The density of water is stated as 1000 kg/m^3, and the volume of the cube is calculated to be 1000 cm^3. An initial calculation mistakenly resulted in 0.01 kg due to errors in unit conversion and arithmetic. After troubleshooting, it was revealed that a miscalculation occurred when dividing 10000 by 100, leading to confusion about the result. Ultimately, the correct understanding clarified that the mass of the cube is indeed 1 kg.
Psip
Messages
13
Reaction score
0

Homework Statement


The density of water is given to be 1000kg/m^3 use unit conversion to show a cube of water with a side length of 10cm has a mass of 1kg.

Homework Equations


mass=volume x density

The Attempt at a Solution


1000kg/m^3*1000cm^3*1m/100cm*1m/100cm*1m/100cm=.01kg all meters and centimeters should cancel only leaving kilograms and the 1000cm^3 is the volume of the cube if each side is 10cm. So if you use the formula and multiply the volume and density then cancel the length units I should get 1kg according to the book but I'm 10 times too small. What did I do wrong?
 
Physics news on Phys.org
Try separating the operations with parentheses. Might help to put away the calculator --- it's all powers of 10.
 
Thanks for the reply but I tried that and I still get the wrong answer
 
One step at a time, then; "100x100?"
 
Ah yes I see thanks for your help the actual problem was that when I did 10000/100 it gives 100 but I thought that I didn't hit the button because it looks like the 100 never changed so it was a weird mistake on my part.
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Correct statement about a reservoir with an outlet pipe'
The answer to this question is statements (ii) and (iv) are correct. (i) This is FALSE because the speed of water in the tap is greater than speed at the water surface (ii) I don't even understand this statement. What does the "seal" part have to do with water flowing out? Won't the water still flow out through the tap until the tank is empty whether the reservoir is sealed or not? (iii) In my opinion, this statement would be correct. Increasing the gravitational potential energy of the...
Back
Top