Displacement on a Position vs. Time Graph

AI Thread Summary
The discussion revolves around calculating the runner's displacement between 10 and 20 minutes on a position vs. time graph. The positions at these times are 3000 m and 3500 m, respectively, leading to an initial calculation of 500 m for displacement. However, a correction reveals that the position at 20 minutes should be 3400 m instead of 3500 m, changing the displacement calculation to 400 m. The importance of ensuring accurate data entry, especially in online formats, is highlighted. Accurate interpretation of graph data is crucial for solving displacement problems effectively.
greenwave
Messages
2
Reaction score
0

Homework Statement


The graph is of a runner-
time(min) is the x
position(x1000 m) is the y
these are the points
0,0
10,3
20,3.5
30,4.5

The question is- For the time interval between 10 min and 20
min, what is the runner’s displacement?
Answer in units of m



Homework Equations





The Attempt at a Solution


The position for 10 min is 3000 and the position for 20 is 3500. I subtracted 3500 from 3000 to get 500, what i thought would be the displacement. This is not the answer however and i don't know any other way to work out this problem. Help is appreciated, thanks!
 
Physics news on Phys.org
Hmmm... I think you are correct unless this is a funny question. If this was an online question, did you enter the units?
 
Turns out it was 20,3.4 and not 3.5. Thanks though
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Correct statement about a reservoir with an outlet pipe'
The answer to this question is statements (ii) and (iv) are correct. (i) This is FALSE because the speed of water in the tap is greater than speed at the water surface (ii) I don't even understand this statement. What does the "seal" part have to do with water flowing out? Won't the water still flow out through the tap until the tank is empty whether the reservoir is sealed or not? (iii) In my opinion, this statement would be correct. Increasing the gravitational potential energy of the...
Back
Top