Find resistance of copper wire.

AI Thread Summary
The resistance of a 1.4 m length of copper wire with a diameter of 5*10^-3 m is calculated using the formula R = p(L/A), where the resistivity of copper is 1.69 * 10^-8. The radius is determined to be 2.5*10^-3 m, leading to an area of approximately 1.96*10^-5 m². Substituting these values into the equation yields a resistance of 1.2*10^-3 Ohm. Initially, the answer was thought to be incorrect, but it was confirmed that the database in the online quiz was faulty. The discussion concludes with relief over resolving the confusion.
Spoonerz
Messages
5
Reaction score
0

Homework Statement


Find the resistance of a 1.4 m length of copper wire with diameter of 5*10^-3 m.

Homework Equations


R = p(L/A) where p = resistivity of copper, L = length, A = area

The Attempt at a Solution


The resistivity of copper is (1.69 * 10^-8). Radius is d/2 (5*10^-3) / (2) = (2.5*10^-3)
With the radius, the Area A = pi(2.5*10^-3)^2 = (1.96*10^-5).

Plugging it into the equation R = p(L/A)
(1.69*10^-8)*(1.4) / (1.96*10^-5) = (1.2*10^-3) Ohm

There were two similar questions like this where the same approach yield me the correct answer. Somehow this answer I get is incorrect. What am I doing wrong?

On a side note, how many questions may I post?
 
Physics news on Phys.org
Spoonerz said:
Plugging it into the equation R = p(L/A)
(1.69*10^-8)*(1.4) / (1.96*10^-5) = (1.2*10^-3) Ohm

1.2*10^-3 Ohm is the correct answer after all. It was just the faulty database in the online quiz. =D
 
Spoonerz said:
1.2*10^-3 Ohm is the correct answer after all. It was just the faulty database in the online quiz. =D

Ouch, that hurts! Glad you got it sorted out.
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Struggling to make relation between elastic force and height'
Hello guys this is what I tried so far. I used the UTS to calculate the force it needs when the rope tears. My idea was to make a relationship/ function that would give me the force depending on height. Yeah i couldnt find a way to solve it. I also thought about how I could use hooks law (how it was given to me in my script) with the thought of instead of having two part of a rope id have one singular rope from the middle to the top where I could find the difference in height. But the...
Back
Top