How Do You Calculate the Angular and Linear Speed of a Ball?

AI Thread Summary
To calculate the angular speed of a ball moving at 5000 rpm with a radius of 4 cm, the angular speed is determined to be approximately 523.6 radians per second. The period of rotation is calculated using the formula T = 2π/ω, resulting in a period of about 0.012 seconds. The linear speed of a point on the outer edge of the ball can be derived from the angular speed and radius, while the linear acceleration can be calculated using the linear speed and the radius. The discussion highlights the importance of unit conversion and accuracy in calculations. Overall, the calculations for angular speed and period appear to be correct, but further clarification is sought on the linear speed and acceleration.
imy786
Messages
321
Reaction score
0

Homework Statement



a ball moves at 5000 rpm (revolutions per minute). Their radius is 4 cm.

(i)Determine the angular speed in radians per second.

(ii) Find the period of rotation

(iii) Find the linear speed of a point on the outer ball

(iv) Find the linear acceleration of a point on the outer edge of the ball.

Homework Equations



angular speed = 2∏ / T

The Attempt at a Solution



(i)

r = 4cm = 0.04m
circumference = 2∏r = 0.08∏

1 rev = 2∏°
5000 rev/min = 5000 X 2∏° / min
10,000∏° / min
10,000∏° / min = 10,000∏° per 60 secs

10,000∏° / 60 = 166.67∏°/sec

angular speed = 166.67∏°/sec

is this correct for part (i)
 
Last edited:
Physics news on Phys.org
1 rev = 2∏ radians = 360° ; be careful with your units.
You might as well say that omega = 523.6 rad/sec.
 
Find the period of rotation

T = 2 ∏ / omega = 2∏/523.6 = 0.012 seconds
 
is this correct?
 
why isn't anyone responding?
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Struggling to make relation between elastic force and height'
Hello guys this is what I tried so far. I used the UTS to calculate the force it needs when the rope tears. My idea was to make a relationship/ function that would give me the force depending on height. Yeah i couldnt find a way to solve it. I also thought about how I could use hooks law (how it was given to me in my script) with the thought of instead of having two part of a rope id have one singular rope from the middle to the top where I could find the difference in height. But the...
Back
Top