How Fast is the Skier Traveling Before Landing?

  • Thread starter Thread starter benji
  • Start date Start date
AI Thread Summary
An extreme skier starts from rest and coasts down a 25-degree slope for 10.4 meters before jumping off a cliff, landing 3.5 meters below. The skier's velocity just before landing is calculated using energy principles, with the correct answer being 10.9 m/s. Initial calculations suggested a speed of 9.29 m/s, but adjustments for vertical and horizontal components of velocity resulted in a final impact speed of approximately 12.41 m/s. The discussion emphasizes using energy conservation and the work-energy principle, factoring in kinetic friction. The importance of correctly accounting for all forces and energy transformations in the problem is highlighted.
benji
Messages
48
Reaction score
0
Alright, so here's the problem:

An extreme skier, starting from rest, coasts down a mountain that makes an angle of 25.0-degrees with the horizontal. The coefficient of kinetic friction between her skis and the snow is 0.200. She coasts for a distance of 10.4 m before coming to the edge of a cliff. Without slowing down, she skis off the cliff and lands downhill at a point whose vertical distance is 3.50 m below the edge. How fast is she going just before she lands?

So I didn't want to explain everything I tried, so I just scanned my paper ;). Here it is:

http://img129.exs.cx/img129/6093/physics_problem.gif

Can anyone see what I'm doing wrong? The correct answer is supposed to be 10.9 m/s...
 
Physics news on Phys.org
Don't use forces, use energy

the velocity whe the skier leaves the cliff is...
\frac{1}{2}mv^2 = mgh while h = 10.4m sin 25
v = sqrt(2g(10.4 sin 25)) = 9.29 m/s

the skiers velocity is 25 degrees below the horizontal, thus
v_x = v cos 25 \ v_y = v sin 25
thus solve for the time to fall the height 3.5 m
0m = 3.5 m - v sin 25 t - 1/2 g t^2
t= 0.53s

and when the skier makes impact the velocity is
v_y = v sin 25 + 9.8 (0.53 s)
v_x = v cos 25
so the total velocity at impact is..
v = sqrt( (v_x)^2+(v_y)^2) = 12.4128 m/s

so i believe your answers wrong doing this is also very complicated but i thought would make u believe the answer more cause I use projectiles, gravity is a conservative force so therefore it doesn't matter what path the skier takes to drop the height u can find the velocity by 1/2mv^2 = mgh
where h is (10.4m sin 25 + 3.5m) the total height from the ground. you'll get the same result.

edit: i forgot the coff of friction, however use work engery principle in the same way i did this problem that might help
 
Last edited:
Your sum of all x component forces :
F_{g}sin25-F_{fricition}=ma_x
Your sum of all y component forces :
\Sigma F_{y}=ma_y
N-mgcos25=0
 
Last edited:
Thanks guys, really appreciate your help.
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Correct statement about a reservoir with an outlet pipe'
The answer to this question is statements (ii) and (iv) are correct. (i) This is FALSE because the speed of water in the tap is greater than speed at the water surface (ii) I don't even understand this statement. What does the "seal" part have to do with water flowing out? Won't the water still flow out through the tap until the tank is empty whether the reservoir is sealed or not? (iii) In my opinion, this statement would be correct. Increasing the gravitational potential energy of the...
Back
Top