How Long Does It Take for a Mass to Oscillate Between Two Points on a Spring?

AI Thread Summary
A vertical spring stretches 9.6 cm with a 1.3 kg block, which is then displaced an additional 5.0 cm and released. The problem involves calculating the time for the mass to oscillate between two points, 0.025 m above and below the equilibrium position. The correct angular frequency is determined to be 10.1, leading to the equations X1 and X2 for the oscillation. The initial calculations led to confusion regarding the use of radians versus degrees, which affected the time values. Ultimately, the correct times are t1 = 0.1 seconds and t2 = 0.2 seconds, confirming a total time change of 0.1 seconds.
shasanni
Messages
3
Reaction score
0

Homework Statement



A vertical spring stretches 9.6 cm when a 1.3kg block is hung from its end.This block is then displaced an additional 5.0 cm downward and released from rest. Calculate the time it takes the object to go from a point 0.025 m below its equilibrium position to a point 0.025 m above it.


Homework Equations


X1= Acos(Wt1)
X2=Acos(Wt2)
A represents the amplitude, which is 0.05 m. The W represents the angular frequency, which is 10.1




The Attempt at a Solution


This is how I sent things up:
0.025=0.05cos(10.1t1)
-0.025=0.05cos(10.1t2)
and then I would have subtracted the two times, but I am not getting the correct values for t1 and t2. What am I doing wrong??
Btw, the answer is supposed to be 0.1s. T2 is 0.2s and T1 is 0.1s. ?
 
Last edited:
Physics news on Phys.org
What did you get for t1 and t2?

ehild
 
This are the values I get:
t1= 0.507
t2=-.0507
 
cos(ωt1)=0.5 corresponds to ωt1=π/3.
cos(ωt2)=-0.5 corresponds to ωt2=π-π/3.
What are t1 and t2 then?

ehild
 
i think I know what the issue is. I have been using radians, not degrees!
t1 should 0.1 seconds and t2 should be 0.2 s. The change in time should be 0.1 seconds, which is the answer.
 
Well done! take care of radians and degrees in the future.

ehild
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Correct statement about a reservoir with an outlet pipe'
The answer to this question is statements (ii) and (iv) are correct. (i) This is FALSE because the speed of water in the tap is greater than speed at the water surface (ii) I don't even understand this statement. What does the "seal" part have to do with water flowing out? Won't the water still flow out through the tap until the tank is empty whether the reservoir is sealed or not? (iii) In my opinion, this statement would be correct. Increasing the gravitational potential energy of the...
Back
Top