How to find theta in a mutiple slit question

AI Thread Summary
To find the angle for the first order peak of red photons using a diffraction grating with 14100 lines per 2.54 cm, the formula d sinΘ = m λ is applied. The calculation for d yields 1.801E-6 m, and using this value, the angle Θ is calculated as sin^-1(656E-9 / 1.801E-6), resulting in 21.36 degrees. Despite this calculation appearing correct, the answer is not accepted by the system, leading to uncertainty about potential mistakes. The discussion concludes with confirmation that the calculations were performed correctly, but the exact correct answer remains unknown.
MartinFreeman
Messages
11
Reaction score
0

Homework Statement



A diffraction grating with 14100 lines per 2.54 cm (i.e., per in.) is used to view the visible spectrum from a Hydrogen gas excited by an electrical discharge. At what angle from the beam axis will the first order peak for the red photons with wavelength of 0.656 μm occur?

Homework Equations



d sinΘ= m λ

The Attempt at a Solution


[/B]
I think I've got the right awnser, but apparent not.

so here is what I've done , to get d : 0.0254m/14100 = 1.801E-6

Θ = sin^-1 ( 656E-9 / 1.801E-6 ) = 21.36ο .

However, this is not the correct answer. I was wondering how I might have made a mistake?
 
Physics news on Phys.org
I have a feeling that maybe this question is much more complicated than my 3 step calculation...
 
MartinFreeman said:

Homework Statement



A diffraction grating with 14100 lines per 2.54 cm (i.e., per in.) is used to view the visible spectrum from a Hydrogen gas excited by an electrical discharge. At what angle from the beam axis will the first order peak for the red photons with wavelength of 0.656 μm occur?

Homework Equations



d sinΘ= m λ

The Attempt at a Solution


[/B]
I think I've got the right awnser, but apparent not.

so here is what I've done , to get d : 0.0254m/14100 = 1.801E-6

Θ = sin^-1 ( 656E-9 / 1.801E-6 ) = 21.36ο .

However, this is not the correct answer. I was wondering how I might have made a mistake?

What you have done is correct. What are you told is the correct answer?
 
lychette said:
What you have done is correct. What are you told is the correct answer?
Unfortunately the system only accepts correct answers, but does not accept wrong awnsers, So... i don't know. But it's good to know i did the right work. Il mark it solved , thanks for your help.
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Correct statement about a reservoir with an outlet pipe'
The answer to this question is statements (ii) and (iv) are correct. (i) This is FALSE because the speed of water in the tap is greater than speed at the water surface (ii) I don't even understand this statement. What does the "seal" part have to do with water flowing out? Won't the water still flow out through the tap until the tank is empty whether the reservoir is sealed or not? (iii) In my opinion, this statement would be correct. Increasing the gravitational potential energy of the...
Back
Top