Physics Lab Question - High School

AI Thread Summary
In the physics lab on specific heat, the cool water was intentionally started below room temperature to minimize heat loss to the environment during the experiment. This approach allows the water to first absorb heat from its surroundings before the heated metal is added, which helps achieve a more accurate final temperature measurement. The final temperature of the water, after adding the metal, was between 26-30 degrees Celsius, slightly above room temperature. This method balances heat gain and loss, reducing errors in the results. Overall, starting with cooler water enhances the accuracy of specific heat calculations.
PlanetLazy
Messages
6
Reaction score
0
In my introductory physics class in high school we did a lab on specific heat. We heated metals and placed them into cool water and observed the temperature change to find the specific heat of the metal. One of the questions on the lab puzzled me.
- Why was the cool water purposely started well below room temperature?
What is the reason for having the water below room temperature?
 
Physics news on Phys.org
What was the final temperature of water after adding the metal piece? Was it above room temperature?

ehild
 
ehild said:
What was the final temperature of water after adding the metal piece? Was it above room temperature?

ehild

it was between 26 - 30 degrees celsius which is a little above room temperature.
 
The water exchanges some heat with the surroundings. If the water is initially at room temperature, it losses heat all the time during the metal warms it up. That causes error in the final temperature.

If you start below room temperature, the water gets heat from the surroundings first, and when it warms above room temperature, it losses heat. The gain and loss about cancel each other.
The best is when you find a balance, so as the room temperature is halfway between the initial and final temperature of water.

ehild
 
thank you very much and great explanation!
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Correct statement about a reservoir with an outlet pipe'
The answer to this question is statements (ii) and (iv) are correct. (i) This is FALSE because the speed of water in the tap is greater than speed at the water surface (ii) I don't even understand this statement. What does the "seal" part have to do with water flowing out? Won't the water still flow out through the tap until the tank is empty whether the reservoir is sealed or not? (iii) In my opinion, this statement would be correct. Increasing the gravitational potential energy of the...
Back
Top