Pressure Problem: Calculating Gauge Pressure in a Layered Salad Dressing

  • Thread starter Thread starter Meowserkitty
  • Start date Start date
  • Tags Tags
    Pressure
AI Thread Summary
The discussion focuses on calculating gauge pressure in a layered salad dressing consisting of cream, oil, and vinegar. The order of layers from top to bottom is identified as oil, cream, and vinegar based on their densities. To calculate gauge pressure at the bottom of the jar, one must determine the absolute pressure by summing the pressures of each liquid layer and then subtracting atmospheric pressure. The correct formula for pressure change is highlighted as density multiplied by gravity and height. Understanding these calculations is essential for accurately determining the gauge pressure in this scenario.
Meowserkitty
Messages
14
Reaction score
0

Homework Statement



A creamy salad dressing is made up of heavy cream, corn oil, and vinegar (as well as a pinch of dry mustard, salt and pepper). You put the cream, oil, and vinegar in a glass jar. The density of the cream is 994 kg/m3, the oil 880 kg/m3, and the vinegar 1000 kg/m3. The salad dressing liquids separate into three layers. (a) What is the order of the layers from top to bottom? (b) If the cream layer is 2.20×10−2 m tall, the oil layer 2.80×10−2 m tall, and the vinegar layer 1.60×10-2 m tall, what is the gauge pressure at the bottom of the jar?

Homework Equations



Patm= 1.013 x 10^5 Pa

P=F/Area or P= Density x gravity x height

The Attempt at a Solution



I got a) Oil, cream, vinegar because the one with the least density would float on top etc.

B confuses me because I don't understand how to calculate Gauge Pressure
 
Physics news on Phys.org
Gauge pressure is the absolute pressure minus atmospheric pressure.
 
How would you find absolute with all of those, would you calculate the pressure of each layer, add them together and subtract atmospheric? Or is Atm. not in it already?
 
Meowserkitty said:
How would you find absolute with all of those, would you calculate the pressure of each layer, add them together and subtract atmospheric? Or is Atm. not in it already?

The pressure above the top layer is 1 atm. Your equation for pressure is not correct. It should read

change in pressure over height of layer = density x gravity x height
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Trying to understand the logic behind adding vectors with an angle between them'
My initial calculation was to subtract V1 from V2 to show that from the perspective of the second aircraft the first one is -300km/h. So i checked with ChatGPT and it said I cant just subtract them because I have an angle between them. So I dont understand the reasoning of it. Like why should a velocity be dependent on an angle? I was thinking about how it would look like if the planes where parallel to each other, and then how it look like if one is turning away and I dont see it. Since...
Back
Top