Time to Hit the Ground for Thrown Rock?

AI Thread Summary
A rock is thrown vertically upward at 17.0 m/s from a 60.0 m high building, and the goal is to determine the time it takes to hit the ground. The equations of motion, including v^2 = vinitial^2 + 2a(y - yinitial) and y = Vi*t + ½at², are discussed for calculating the time. Initial calculations using Vf = Vi + a*t yielded an incorrect time of 2.17 seconds, prompting a reevaluation. The correct time to reach the ground, after considering the rock's ascent and descent, is found to be just over 5.5 seconds using both methods. The discussion emphasizes the importance of verifying calculations to avoid mistakes.
rpgnick85
Messages
13
Reaction score
0

Homework Statement



A rock is thrown vertically upward with a speed of 17.0 from the roof of a building that is 60.0 above the ground. Assume free fall. In how many seconds after being thrown does the rock strike the ground?

Homework Equations



I used v^2 = vinitial^2 + 2a(y - yinitial) to find the speed when it hits the ground. I am trying to find the time and can't seem to locate a good equation to use.
 
Physics news on Phys.org
From your initial and final v's, you could get the time with Vf = Vi + a*t.
Or start again and use good old y = Vi*t + ½at².
Best to do it both ways as a check!
 
I used Vf = Vi + a*t with Vf = 38.3, Vi = 17, a = 9.8 and came up with t = 2.17 but that is the incorrect answer for when the rock hits the ground. The rock went up at a starting point of 60m, then came down past 60m to hit the ground.
 
I got a time of just over 5 and a half seconds by both methods. Of course I often make mistakes now - I'm over 60. Show your calc if you want a critique.
 
t = (vf - vi)/a so (38.3-17)/9.8 unless i used the wrong formula
 
Initial v is 17. Final v is -38.3. Difference is 55.3.
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Struggling to make relation between elastic force and height'
Hello guys this is what I tried so far. I used the UTS to calculate the force it needs when the rope tears. My idea was to make a relationship/ function that would give me the force depending on height. Yeah i couldnt find a way to solve it. I also thought about how I could use hooks law (how it was given to me in my script) with the thought of instead of having two part of a rope id have one singular rope from the middle to the top where I could find the difference in height. But the...
Back
Top