What are the units for Molar Mass in Chemistry and Physics?

  • Thread starter Thread starter SAT2400
  • Start date Start date
  • Tags Tags
    Unit
AI Thread Summary
The unit for molar mass can be expressed as grams per mole (g/mol) or kilograms per mole (kg/mol), depending on the context. In chemistry, g/mol is commonly used, while physics typically uses kg/mol as the SI unit. Both units are acceptable, and the choice often depends on the specific problem or teacher's preference. It's important to ensure that units are consistent and properly converted when necessary. Ultimately, there is no single "correct" unit for molar mass; it varies based on the discipline and context of the question.
SAT2400
Messages
68
Reaction score
0
Unit for Molar Mass(M)??

Homework Statement


What's the unit for Molar mass? Is it different in CHemistry and Physics?

Homework Equations


PV=nRT

The Attempt at a Solution


In Chemistry class(last year) I think I used (g/mol).
But in Physics, my teacher says it's (kg/mol).
What is right??
THanks
 
Physics news on Phys.org


SAT2400 said:

Homework Statement


What's the unit for Molar mass? Is it different in CHemistry and Physics?

Homework Equations


PV=nRT

The Attempt at a Solution


In Chemistry class(last year) I think I used (g/mol).
But in Physics, my teacher says it's (kg/mol).
What is right??
THanks

In Physics, the SI unit for mass is the Kg. In chemistry, it usually is grams but it also depends on the type of questions you do and what S! unit the question asks for.
 


g/mol, kg/mol, slugs per mol, and (whatever other mass unit) per mol are all fine for both physics and chemistry. However, it may be more convenient to use a certain unit for certain calculations.
 


It is like asking which is a 'correct' pressure unit - PSI, atm or Pascal.
 


In your assignments and tests, use whichever you feel more comfortable with. Then just convert the answer to the units your teacher wants. There is no "correct" unit here, just your teacher's personal preference.

If you are careful to always make sure your units check out and cancel properly, there should be no problem.
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Correct statement about a reservoir with an outlet pipe'
The answer to this question is statements (ii) and (iv) are correct. (i) This is FALSE because the speed of water in the tap is greater than speed at the water surface (ii) I don't even understand this statement. What does the "seal" part have to do with water flowing out? Won't the water still flow out through the tap until the tank is empty whether the reservoir is sealed or not? (iii) In my opinion, this statement would be correct. Increasing the gravitational potential energy of the...
Back
Top