What fraction of the distance do the block move?

  • Thread starter Thread starter JD<3
  • Start date Start date
  • Tags Tags
    Block Fraction
AI Thread Summary
The discussion focuses on determining the fraction of distance s that a block slides after reaching the bottom of a frictionless ramp and transitioning to a rough horizontal plane. The key question is how far the block travels before its speed decreases to one-third of its maximum speed. Participants express confusion over the relationship between speed reduction and distance, with one suggesting that the answer might be s/3. However, others note the lack of critical information, such as the angle of the surfaces and the friction coefficient, which are necessary for solving the problem accurately. The conversation highlights the importance of understanding the physics involved in motion and friction.
JD<3
Messages
2
Reaction score
0
A block slides a distance d down a frictionless plane and then comes to a stop after sliding a distance s across a rough horizontal plane, as shown in the accompanying figure.

What fraction of the distance s does the block slide before its speed is reduced to one-third of the maximum speed it had at the bottom of the ramp?

a) s/3
b) 2s/3
c) s/9
d) 8s/9

Thanks for the help! :)
 

Attachments

  • Screen shot 2012-02-29 at 9.30.16 PM.png
    Screen shot 2012-02-29 at 9.30.16 PM.png
    4 KB · Views: 664
Physics news on Phys.org
could you show what attempts you have made at solving the problem?
 
I thought that since it is reduced by 1/3 then it would be s/3. But I'm so confused because I know when something is reduced then you multiply to find the number.
 
Is that all of the information that they gave you? It seems like they would have given you some other information, such as the angle between the smooth and rough surface, and especially the friction coefficient for the rough surface (usually denoted by the symbol μ).
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Correct statement about a reservoir with an outlet pipe'
The answer to this question is statements (ii) and (iv) are correct. (i) This is FALSE because the speed of water in the tap is greater than speed at the water surface (ii) I don't even understand this statement. What does the "seal" part have to do with water flowing out? Won't the water still flow out through the tap until the tank is empty whether the reservoir is sealed or not? (iii) In my opinion, this statement would be correct. Increasing the gravitational potential energy of the...
Back
Top