What Is the Speed and Average Acceleration of the Minute Hand on a Clock?

AI Thread Summary
The discussion focuses on calculating the speed and average acceleration of a clock's minute hand, given a radius of 25 cm. The speed was determined by calculating the circumference and dividing it by 3600 seconds. The angle moved from the 12 to the 2 position is confirmed to be 60 degrees, or π/3 radians. Average acceleration is stated to be zero, assuming constant angular velocity. Participants also suggest resources for better understanding radians and provide analogies to clarify the calculations.
StupidGenius
Messages
19
Reaction score
0

Homework Statement


Calculate the speed of the minute hand on the clock (I solved with the assumption of the minute hand being the radius) with the length of 25 cm.

How many degrees did the minute hand move through from 12" point to 2" point?

What is the average acceleration?


Homework Equations


a=change in V/change in time




The Attempt at a Solution



So i found the speed of the hand by finding circumference then divided over 3600 seconds.

Now I need to find the angle from 12" to 2". Is it right to assume that 2" is at 45 degrees, if 3" is 90 degrees?
Which method should I use the component or the trig method?
please help.

PS: is there a way to illustrate this and post it up?
 
Physics news on Phys.org
I calculated the average angular velocity to be 1.745x10^-3 rad/s

Average acceleration will be 0, assuming that the average angular velocity is constant.

Is this what you are after?

there are 12 points on a clock face, so (2pi/12)*2 will give you the angle in radians between 12 and 2.

Its 60deg :P or pi/4
 
Gorz said:
I calculated the average angular velocity to be 1.745x10^-3 rad/s

Average acceleration will be 0, assuming that the average angular velocity is constant.

Is this what you are after?

there are 12 points on a clock face, so (2pi/12)*2 will give you the angle in radians between 12 and 2.

Its 60deg :P or pi/4

60 deg is right, but would you mind explaining it to me in a simpley way? or maybe introduce radians because we just skimmed over that section.
 
StupidGenius said:
thanks but still not quite sure how you arrived at the answer

What would happen if you cut a cake into 12 pieces and remove 2 pieces from the cake? How many degrees would the 2 pieces of cake be worth.

360/12 = 30, 30*2=60

Or in Radians, Pi = 180, so 2pi/12 *2 = pi/3
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Correct statement about a reservoir with an outlet pipe'
The answer to this question is statements (ii) and (iv) are correct. (i) This is FALSE because the speed of water in the tap is greater than speed at the water surface (ii) I don't even understand this statement. What does the "seal" part have to do with water flowing out? Won't the water still flow out through the tap until the tank is empty whether the reservoir is sealed or not? (iii) In my opinion, this statement would be correct. Increasing the gravitational potential energy of the...
Back
Top