Why Did My Financial Calculator Stop Working?

  • Thread starter Thread starter slipkorn17
  • Start date Start date
  • Tags Tags
    Broken Calculator
AI Thread Summary
A user experienced issues with their financial calculator, which flashed on and off, indicating a possible loose connection. Upon inspection, they discovered a disconnected black wire from the B- terminal and a red wire that seemed to need reattachment to the battery. Suggestions included using a heated screwdriver for emergency soldering and lemon juice as a flux alternative. The discussion also touched on a puzzling metal piece, speculated to be a solderless clip for the battery. Ultimately, the user successfully completed their finance final with a high score despite the calculator troubles.
slipkorn17
Messages
3
Reaction score
0
Hello all,

So I write a finance final tomorrow morning and my financial calculator decided to quit working on me. The screen would flash as it turned off and on rapidly, almost as if there was a loose connection. So I popped 'er open and here is what I found:

http://i.imgur.com/UdASBX1.jpg

It looks like the red wire needs to be attached to the other side of the battery, but when I hold it there, it does not turn on. It also doesn't look like anything was soldered on to that side of the battery before. I'm also confused by the weird metal piece.

Thanks in advance.
 
Engineering news on Phys.org
Nevermind, the black wire just came off of the B- terminal. It's pretty much toast now without a soldering iron.
 
try heating the tip of a screwdriver on your stove for an emergency soldering iron.
Try a little lemon juice for flux, but rinse well.

.
 
jim hardy said:
try heating the tip of a screwdriver on your stove for an emergency soldering iron.
Try a little lemon juice for flux, but rinse well.

And for really fine work, a finishing nail held in Vise-Grips works too. Neat tip about the juice; I never heard of that one before. Thanks.

Slipkorn, is that puzzling piece of metal actually attached to the top of the case, or just lying there? I ask because it sort of looks as if it might be a solderless clip to attach to the battery.
 
17 months later - I just went out and bought a decent one for $60. Used it for that final and never again. Maybe I'll use it in my last year starting next week. Thanks for responses, though.

Killed the final, by the way. Ended the course with a 90+.
 
I used to be an HVAC technician. One time I had a service call in which there was no power to the thermostat. The thermostat did not have power because the fuse in the air handler was blown. The fuse in the air handler was blown because there was a low voltage short. The rubber coating on one of the thermostat wires was chewed off by a rodent. The exposed metal in the thermostat wire was touching the metal cabinet of the air handler. This was a low voltage short. This low voltage...
Hey guys. I have a question related to electricity and alternating current. Say an alien fictional society developed electricity, and settled on a standard like 73V AC current at 46 Hz. How would appliances be designed, and what impact would the lower frequency and voltage have on transformers, wiring, TVs, computers, LEDs, motors, and heating, assuming the laws of physics and technology are the same as on Earth?
Thread 'How Does Jaguar's 1980s V12 Dual Coil Ignition System Enhance Spark Strength?'
I have come across a dual coil ignition system as used by Jaguar on their V12 in the 1980's. It uses two ignition coils with their primary windings wired in parallel. The primary coil has its secondary winding wired to the distributor and then to the spark plugs as is standard practice. However, the auxiliary coil has it secondary winding output sealed off. The purpose of the system was to provide a stronger spark to the plugs, always a difficult task with the very short dwell time of a...

Similar threads

Back
Top