Recent content by John1397

Shaded pole motor is already wound if it has 3rd wire ground should be safe , refrigerator fan motor might work good.

I see different growlers and the one that seems the best uses 28 gauge copper wire X 2800 turns hooked to 120 volts AC does this sound right? I think this can be figured out using ohms law to so the windings do not get hot when AC is applied.

98 puts it in North Dakota

I have two longitude decimals readings and they are .11330 apart how many feet is this?

Somebody thinks this will work three diodes in row cuts voltage from 5 to 1.5.

See what a seller on Ebay writes about batteries.

The manufacturer in China says not to use rechargeable or alkaline batteries even Seikos website says no alkaline batteries, seems to me on DC you only have volts and amps.

I never had quartz clock I see you need to use carbon battery, I am thinking start with 1000 ohm resistor and see if clock runs with alkaline battery if not just keep lowering resistance.

Seen that throwing stick in water time how many seconds from into out works to.

I am trying to figure out the fps of 18 inch culvert with 13.5 inches water over the top on inlet and about 2 inches lower on the outlet and 2 inch drop on the outlet end over 40 foot length, what I need to know what would be the headwater on this type of configuration?

Attached formula can't figure out. H is 12 inches, Q is what I want to know, L is 40 feet, D is 18 inches, A I assume is area of 18 inches, g have no clue what this is. The Culver is 18" X 40 foot long coragated with water 1 foot over inlet and water on outlet 2" lower than culvert and the...

All I need is for someone to look at my schematic and tell me if this circuit will work. Thanks.

Only difference I see and don't understand is motor capacitor is AC and tv capacitor is DC, see no reason to not try either motor will start or not.

Have farm motor 1 hp 600 mf capacitor failed can one slip old tv style capacitor in old can as this motor runs on 220 ac?

I have an AC brush motor it has 12 slots where copper wires go and 24 copper bars, if you take 12 wires and go in a slot and come out at different slot and as you go around you filled all the slots now you have 24 ends 2 wires out of each slot which you connect to the 24 copper bars. Heres the...