Bringing an Old Robot Radio to Life: Building an AM/FM Receiver

AI Thread Summary
To resurrect an old robot radio, building an AM/FM receiver involves understanding modulation basics and signal decoding. Key components include integrated circuits (ICs) and inductors, which play a crucial role in the receiver's functionality. Filters may also be necessary to clean up the received signals for better audio quality. Resources like online guides can provide additional insights into the technical aspects of the project. Successfully reviving the radio requires a solid grasp of these components and their interactions.
Lancelot59
Messages
640
Reaction score
1
Hey PF, I want to resurrect an old robot radio I have sitting around. What exactly is involved with building an AM/FM receiver?
 
Engineering news on Phys.org
Last edited by a moderator:
Well I know how the signal is modulated. I'm just curious as to what is involved with de-coding the signals. I've heard of IC's and inductors being used. Also are any filters needed to clean up the signal?
 

Thread 'Why does the amperage go real high if there is a low voltage short?'

I used to be an HVAC technician. One time I had a service call in which there was no power to the thermostat. The thermostat did not have power because the fuse in the air handler was blown. The fuse in the air handler was blown because there was a low voltage short. The rubber coating on one of the thermostat wires was chewed off by a rodent. The exposed metal in the thermostat wire was touching the metal cabinet of the air handler. This was a low voltage short. This low voltage...
View full post »

Thread 'How might electronics be different if AC voltage was 72V at 45 Hz?'

Hey guys. I have a question related to electricity and alternating current. Say an alien fictional society developed electricity, and settled on a standard like 73V AC current at 46 Hz. How would appliances be designed, and what impact would the lower frequency and voltage have on transformers, wiring, TVs, computers, LEDs, motors, and heating, assuming the laws of physics and technology are the same as on Earth?
View full post »
Thread 'How Does Jaguar's 1980s V12 Dual Coil Ignition System Enhance Spark Strength?'

Thread 'How Does Jaguar's 1980s V12 Dual Coil Ignition System Enhance Spark Strength?'

I have come across a dual coil ignition system as used by Jaguar on their V12 in the 1980's. It uses two ignition coils with their primary windings wired in parallel. The primary coil has its secondary winding wired to the distributor and then to the spark plugs as is standard practice. However, the auxiliary coil has it secondary winding output sealed off. The purpose of the system was to provide a stronger spark to the plugs, always a difficult task with the very short dwell time of a...
View full post »

Similar threads

Am vs Fm variable capacitor receiver, what is the difference?
Replies
2
Views
3K
I tried to build a radio receiver
Replies
11
Views
2K
Hi, has anybody had trouble building the ELENCO 108 AM/FM RADIO KIT
2
Replies
55
Views
6K
Minimum Frequency of FM Data / Catastrophic Error Scenario?
2
Replies
68
Views
5K
Where is the demodulator in this AM receiver?
Replies
12
Views
3K
How does AM broadcasting/receiving work + a project for HS students?
Replies
20
Views
1K
Crystal Radios and Followups
Replies
37
Views
4K
How Can I Build an AM Receiver with Limited Supplies?
Replies
9
Views
2K
Using an inductor choke as a receiving antenna for LW radio
Replies
14
Views
2K
Help with understanding modulation in AM, FM and PM radio
Replies
11
Views
4K

Hot Threads

Recent Insights

Back
Top